Bài đăng

2 người theo dõi Theo dõi
0
Avatar

Several images were turning.

Hi,

Several images of the flight path outside the defined polygon were turning.
I was taking images while the aircraft is turning,like crabbed images.
Is it due to too much along track overlap?

Regards,

Naoki

Naoki

Bình luận chính thức

Avatar

This can happen if you are using Connectionless Mode for data collection since it will take images right through the corners. If you are using Active Connect mode it will only take images when up to speed on the straight passes of the mission. 

If it is windy it can cause the aircraft to crab a bit and the images may not be aligned with the path of travel like we would want. 

It is not due to too much along track overlap. 

Zane
Thao tác bình luận Đường dẫn cố định

Vui lòng đăng nhập để lại bình luận.

4 bình luận

0
Avatar

Could I ask you this question again?

Map Pilot  took any images in the deceleration, corners or acceleration areas.

I tried arranging images of the flight path that my aircraft flew at a later date.

As below.

Also, the flight plan.

inspire1 with X5

iPad mini4 iOS11.41

Active Connect

Overlap 80/80

Max Speed 2.0m/s

Wind Speed 1.04m/s(wind speed by altitude 60m)

 

Thank you and best regards,

Naoki

 

 

 

 

Naoki 0 bình chọn
Thao tác bình luận Đường dẫn cố định
0
Avatar

Ahh. I see. You were flying SUPER slowly which makes it so there is almost no overflight to ramp up and ramp the speed down. We can look at increasing it down at low speeds like that but it doesn't happen if you are flying faster and are in Active Connect mode.

Thanks for the great write up though!

Zane 0 bình chọn
Thao tác bình luận Đường dẫn cố định