Inspire 1 Firmware v.1.5.0.30

We haven't tested it yet but the reports we have had have said it works well. The same is true for the Phantom 3.

Ok thanks, I guess we will give it a try.

Am I right that it now requires you to takeoff and load the mission first or is that fixed again now?

Yes. There has never been a publicly released version that automatically takes off since DJI removed that capability from the public versions of the firmware.

We have had some connection issues since the update. Even following the usual trial of going into DJI GO then closing it hasn't work sometimes and requires a complete reboot to get it to recognize. Will report if it continues to be a problem

There is a new SDK update that they posted recently and we are working to update the app to use that. They very likely go hand in hand. We are hoping it will fix the other connection issues people were having.

I did a trial today but couldn't get the AC linked, for a mission i planned at home.. .. back home and it linked immediately...
some new do's&don'ts...? (it worked 2 weeks ago)

i did another test on the location of the mission but cold not link.
back home it linked again once.
my strategy was normal start up with GoP in P-mode do an initial start motor and stop motors- set to F-mode leave GoP app and immediatly open MmE app, it connected once. but not afterwards.
My total quit of GoP app is: centre ipad botton=leave GoP app / pull out cable to RC. When attach cable again, pop-up [trust this comp] appears / open MmE app
My MmE app : 1.3.2 build011416
App GoP 2.5.1 / AC 1.5.00.30 / RC 1.5.70 / cam 1.5.00.30