Bài đăng

3 người theo dõi Theo dõi
0
Avatar

Mission Upload Attempt Failed

Error "Corner radius invalid". I saw another post where it was likely caused due to the restart waypoint being too close to the next waypoint in the mission. I think this might have been the case as I was just completing a turn before RTH for battery change. I manually selected a point at the start of the turn instead and it seemed to accept it. Although when manually selecting the restart point manually for the above issue i got the below error

Flight Start Error Phantom 4 Advanced
Over maximum flight radius. What does this mean? 
Wasn't sure what to try, I close MPP and opened DJI Go checked a couple of settings closed DJI Go, went back into MPP and uploaded again, this time it worked? 

Glenn Stampalia

Vui lòng đăng nhập để lại bình luận.

4 bình luận

0
Avatar

The corner radius invalid thing happens when 3 consecutive waypoints don't meet certain criteria for distance and angles. It usually happens on flights after the first flight that have an abadonment point near another waypoint. This can easily be worked around by selecting the nearest corner waypoint while the blue verification line is showing so you start there instead of having that extra point in there that is causing the issues.

There will be a fix for this soon since we have been hearing about it a lot lately.

The maximum flight radius is something in the Map Pilot Pro settings that allows you to define an around outside of which you are not allowed to operate. It is under the 'User Interface' section in the settings labeled 'Enable Radius Guide'. When it is enabled you can define a maximum radius for your operating area. 

Or, you didn't have a solid GPS fix yet and it was thinking you were somewhere else. You cannot upload a flight into the system that is further away than the aircraft can physically fly to in a single battery. So just check the location of the red triangle with respect to the defined flight path. 

Zane 0 bình chọn
Thao tác bình luận Đường dẫn cố định
0
Avatar

Thanks for the clarification. How is the mentioned fix going to handle the error? Will it look at the previous waypoint to the one which is receiving the error? Just curious. 

Glenn Stampalia 0 bình chọn
Thao tác bình luận Đường dẫn cố định