Hi,
I've been using Map Pilot for awhile with good success. I've got a P3Pro and a P4. I flew missions yesterday with both. No problems.
Today, went to a new site and created an 8 acre mission at 90% (as I normally do), launched the P3Pro as normal, switched to F mode and tried to upload the mission. The app didn't respond (nothing happened when I tapped Upload). I landed the P3Pro, reset everything and tried again. Same story.
I pulled out the P4. All the equipment is different from the P3Pro setup (even a different iPad Mini). I built the same mission in the P4 iPad and got the same result.
There is no error message at all. Just nothing happens when I tap Upload.
Any idea what might be happening?
Eric
Hmmm... It sounds like you might be close to an airport or other no fly zone. We do not get an error when this is the case so we can't pass the information along to the user. We would love to if we could. We hate mystery errors more than anyone.
You could try flying that site at a lower altitude just to see if it will take off but check the Fly Safe site http://www.dji.com/flysafe to see if that could be the issue.
댓글을 남기려면 로그인하세요.
