Posting

2 pengikut Ikuti
0
Avatar

Map Pilot Pro - Mavic 3M - Camera Settings and RTK Information

Hi Zane, 

Thanks so much to you and the team for your work on the app, it's much improved. Understand the point about the SDK and fair enough there's only so much you can do!

If I may ask another couple of questions please: 

Regarding the camera, the Autofocus/Manual Focus setting is greyed out and the white balance doesn't seem to have any effect, are these settings those affected by the SDK? 

Regarding RTK, I shouldnt first connect to DJI Pilot 2 right? I can do everything from MPP? 

I've got the RTK connection working - great! I have noticed that even when connected, Base and mobile satellite numbers stay only at 4, and the base height stays at 0. 

To make proper use of the RTK system on the Mavic, it's necessary to have more information. Is it possible to have a similar set of information that DJI display in Pilot 2? Signal Strength and projected error (standard deviation as shown) are absolutely critical to monitor throughout the mapping mission or there's a real risk of poor results. Viewing XY positioning of the base (to check the drone is reading it correctly) is also required. Is this something that can be implemented?

Again, I'm really grateful to you guys because MPP is the best mapping software - hands down. Just as a side note, I updated the M3M to it's latest firmware and all seems OK, but I haven't flown yet. 

  • Aircraft Firmware: v06.01.06.06
  • Remote Controller Firmware: v02.00.04.07
Jamie Brookes

Komentar resmi

Avatar
We are still in the process of adding the controls for the M3E/M3M. More camera control modes will be coming in the next releases. There are some limitations in what is available on the latest version of the SDK but we are trying to add what is currently available. 
Regarding RTK, I shouldnt first connect to DJI Pilot 2 right? I can do everything from MPP?
No, not really. MPP has the ability to define a custom network RTK connection. Anything to do with the Base Station has to be done within the DJI Pilot 2. DJI doesn't provide us with these controls.  MPP generally just relays information it receives.
I have noticed that even when connected, Base and mobile satellite numbers stay only at 4, and the base height stays at 0.
MPP relays information. I would look at the information/controls in DJI Pilot for your base station. Is this in error? It is just going to be showing the same information that is available in DJI Pilot. 
Signal Strength and projected error (standard deviation as shown) are absolutely critical to monitor throughout the mapping mission or there’s a real risk of poor results. Viewing XY positioning of the base (to check the drone is reading it correctly) is also required. Is this something that can be implemented?
We will look into adding these entries into the RTK Panel. 
Zane
Tindakan komentar Permalink

Harap masuk untuk memberikan komentar.

1 komentar