Hi there, is there a way to ensure the drone stays completely within the area specified for flying? I recently did a flight with very irregular boundaries over a property and noticed the drone going outside this boundary on its flight path as shown below (for context). Although it did not take photo's while outside the specified area to map this is still an issue as sometimes neighbours will be upset by this.
The white/grey line is where the aircraft will fly. You can bring your boundary in some at that point.
Or...
You can use Connectionless mode which does not have the speed ramp up and ramp down overflight that occurs in Active Connect mode. Connectionless mode does not leave the designated boundary.
Vous devez vous connecter pour laisser un commentaire.
Thanks Zane, I'm assuming to turn connectionless mode on / off is a tick box function in the settings??
It is in the Options Menu. You can toggle between Active Connect and Connectionless.
