Post

3 followers Follow
0
Avatar

Camara Angle Zenmuse X5S in map pilot pro

I try to adjust the camera angle (Zenmuse X5S, Matrice 210V2) from within Map Pilot Pro but the gimbal/camera does not respond. All the other adjustments, like ISO work.
When I do the same with the Mavic 2 Pro the gimbal takes the aquired angle. Do you have any thoughts on this?

info

Official comment

Avatar

Thank you for asking the question publicly despite your trouble logging in...

We will have to test this and get back to you. It is possible it isn't functioning properly but we will fix it in the next release if there is an issue. 

Zane
Comment actions Permalink

Please sign in to leave a comment.

8 comments

0
Avatar

I did not fly with this combination yet. Just played and tested the settings and simulated a couple of tests. That's when I noticed the different behaviour between the M210 and the M2P.   Will try tomorrow and let you know.

info 0 votes
Comment actions Permalink
0
Avatar

When the mission starts the gimbal goes nadir. After that it does not respond to angle-change commands from within the app. It stays at 0 degrees. Only the last step (from 40-45 degrees) the angle changes about 2 degrees. At the end of the mission the gimbal turns in original position (90 degrees).
During the mission the gimbal does respond to the controller angle commands.

info 0 votes
Comment actions Permalink
0
Avatar

Hmmm. The fact that it points down at the beginning means the command is working. We just tested it with an M210 and X4 camera and it would accept the other gimbal angles as expected. We don't currently have an X5S to test with. 

Are you able to fully control the gimbal from the DJI app?

Zane 0 votes
Comment actions Permalink
1
Avatar

DJI Pilot works fine from the CrystalSky. DJI Pilot on iPad is not supported on this system, it is a 210V2. Perhaps there's an issue??

 

info 1 vote
Comment actions Permalink
0
Avatar

I'm having the same issue. However, it is a combination of INSPIRE 2 with the X5S.

It seems that it is not adjusted to the set angle.

BTW, M2P works correctly.


 

 

Naoki 0 votes
Comment actions Permalink
0
Avatar

Hmmm. Sounds like it is X5S specific. We will try to give that a look. Thanks for bringing it up. 

Zane 0 votes
Comment actions Permalink